Luckily, Art-Rolfmao, had a photo of himself sitting in a van, in his "Self Indulgent" collection:
DSCN0001.jpg I printed a photo of "Art Rolfmao"and added duct tape, then taped it to slightly curve backwards to add more of a 3d effect. I put a large pillow inside a Winter Jacket.
Then took all the equipment outside in the Cold and slight Snow-Flurries. Took 19 shots, including 2-Setup ones,
using 2 to 3 SB-800 Flash units on PocketWizard Wireless remotes. After about 8-Trips in-n-out I brought all the props and equipment back inside, getting back to my PC by 11:11 PM. I have not adjusted my camera to our local Daylight-Savings-Time change. Luckily I took the shots early enough.
I set all the usual controls on Adobe Bridge's Raw Import screen. I used only the ones on the first tabbed page: White Balance, Temperature, Tint, Exposure, Recovery, Fill Light, Blacks, Brightness, Contrast, Clarity, Vibrance, and Saturation. The only one I didn't vary is Tint.
Save to a .TIF, opened in PS-CS3 where I cropped it closer to 640px x 480px size. Used the burn tool to burn the right wooden hand. USM-Sharpened and "Save-To-Web". Usually I convert the colorspace before this last step. I don't recall using any adjustment layers since timing was very close to deadline.