| Author | Thread |
|
|
01/03/2012 01:28:12 PM · #476 |
|
|
|
01/03/2012 01:32:13 PM · #477 |
Originally posted by kawesttex:
Pachinko (sp) ball |
no. |
|
|
|
01/03/2012 01:37:38 PM · #478 |
| A piece of metal reflecting in 2 mirrors? |
|
|
|
01/03/2012 01:44:11 PM · #479 |
|
|
|
01/03/2012 01:44:22 PM · #480 |
Originally posted by PGerst:
A piece of metal reflecting in 2 mirrors? |
Close enough! It's a metal ball reflecting in a mirror. Or as  Toddhead likes to refer to it as the worst picture ever taken! |
|
|
|
01/03/2012 02:17:33 PM · #481 |
Originally posted by sempermarine:
Originally posted by kawesttex:
Pachinko (sp) ball |
no. |
How is Pachinko ball wrong, but metal ball is correct?
Pachinko ball |
|
|
|
01/03/2012 02:27:23 PM · #482 |
| potatoes, potahtoes.. Whose up next? |
|
|
|
01/03/2012 02:55:40 PM · #483 |
| Whoo hoo...I'm up...let me see if I have something handy, otherwise, I will early tonight. |
|
|
|
01/03/2012 02:57:53 PM · #484 |
|
|
|
01/03/2012 03:00:26 PM · #485 |
Piece of Metal? Magnet? Brake Caliper?
|
|
|
|
01/03/2012 03:00:53 PM · #486 |
Originally posted by sinistral_leo:
Originally posted by sempermarine:
Originally posted by kawesttex:
Pachinko (sp) ball |
no. |
How is Pachinko ball wrong, but metal ball is correct?
Pachinko ball |
No difference. Except he said mirror and I'm an idiot. My bad.
Message edited by author 2012-01-03 15:04:43. |
|
|
|
01/03/2012 03:02:28 PM · #487 |
Originally posted by PGerst:
 |
Piece of stone cut in half. |
|
|
|
01/03/2012 03:04:10 PM · #488 |
Yes, but that's general, looking for something more specific.
No.
No.
Originally posted by IAmEliKatz:
Piece of Metal? Magnet? Brake Caliper? |
|
|
|
|
01/03/2012 03:04:28 PM · #489 |
No.
Originally posted by sempermarine:
Piece of stone cut in half. |
|
|
|
|
01/03/2012 03:27:47 PM · #490 |
Originally posted by PGerst:
Yes, but that's general, looking for something more specific. |
Can we get a more specific picture then ;) |
|
|
|
01/03/2012 03:46:09 PM · #491 |
|
|
|
01/03/2012 03:59:53 PM · #492 |
Nope.
Originally posted by kirbic:
A "crush washer"? |
|
|
|
|
01/03/2012 04:23:27 PM · #493 |
| Is it a 'stopper' or plug of some kind? |
|
|
|
01/03/2012 04:28:30 PM · #494 |
|
|
|
01/03/2012 04:42:20 PM · #495 |
No.
Originally posted by m_a_r_c:
Is it a 'stopper' or plug of some kind? |
|
|
|
|
01/03/2012 04:42:40 PM · #496 |
There is more than one type of metal in there.
Originally posted by kirbic:
A bi-metallic device? |
|
|
|
|
01/03/2012 04:48:52 PM · #497 |
| That still doesn't really help much.. |
|
|
|
01/03/2012 05:02:24 PM · #498 |
Originally posted by PGerst:
|
Bullet? looks like lead and copper to me.
Message edited by author 2012-01-03 17:05:19. |
|
|
|
01/03/2012 05:03:46 PM · #499 |
OK, some specific questions:
1.) Is the near-vertical mark in the top section actually a split, or just a very straight scratch?
2.) If a split, is this part of the function of the part?
3.) Is the center layer copper?
4.) Is the powdery-looking surface below the coppery layer actually corroded, or is it something else?
5.) Assuming the part is round, what's the approximate outside diameter?
|
|
|
|
01/03/2012 05:13:45 PM · #500 |
HAHA..ok, good questions, I'll answer them this way.
Its a scratch and irrelevant to figuring out what it is.
I don't know the composition off hand, but I'll look them up later and post them after a few more failed guesses :)
Look at the image information for both the camera and lens to figure out the size. The lens was about 10 cm away.
Originally posted by kirbic:
OK, some specific questions:
1.) Is the near-vertical mark in the top section actually a split, or just a very straight scratch?
2.) If a split, is this part of the function of the part?
3.) Is the center layer copper?
4.) Is the powdery-looking surface below the coppery layer actually corroded, or is it something else?
5.) Assuming the part is round, what's the approximate outside diameter? |
|
|
Home -
Challenges -
Community -
League -
Photos -
Cameras -
Lenses -
Learn -
Help -
Terms of Use -
Privacy -
Top ^
DPChallenge, and website content and design, Copyright © 2001-2025 Challenging Technologies, LLC.
All digital photo copyrights belong to the photographers and may not be used without permission.
Current Server Time: 08/04/2025 06:48:39 AM EDT.
