| Author | Thread |
|
|
03/01/2010 06:01:50 AM · #1 |
I have an st-e2 infrared transmitter on my 7d and two 580 exII set as slaves, one in group A and one in group B
They were working perfectly for a while then they started firing at different times, one flash fired about one second after the first!
I replaced the batteries in both flashes, swapped the position of the flashes, both were around 1m away with perfect line of sight to the st-e2 but still didn't work correctly.
I went back and had another look a little while later and they started working perfectly again!!!
So I don't think it was a fault, I can only assume I've set something strange ... anyone got any ideas?? I've checked the manual and nothing obvious jumped out... |
|
|
|
03/01/2010 05:42:18 PM · #2 |
| bounce ... stumped ya all then :) |
|
|
|
03/09/2010 03:55:59 PM · #3 |
| Sounds like one flash has been set at rear sync but can you even do that when using remotely?? |
|
Home -
Challenges -
Community -
League -
Photos -
Cameras -
Lenses -
Learn -
Help -
Terms of Use -
Privacy -
Top ^
DPChallenge, and website content and design, Copyright © 2001-2025 Challenging Technologies, LLC.
All digital photo copyrights belong to the photographers and may not be used without permission.
Current Server Time: 12/25/2025 04:36:03 PM EST.
